Framing in the hiding spot for our TV bracket

After positioning the TV, the next step is to frame up the space that will hold the bracket out of direct eyesight.  Peter cut out 3 vertical 2×4 supports (outside supports 1st leaving the middle one in until the new supports are installed).  The pictures below illustrate the tools used and the process.  A circular saw (not shown) was used to make the initial cut and then the reciprocating saw was used to cut behind the support.

Reciprocating saw used to cut through nails.
Bent saw blade to cut nails behind the 2x4

Summary of the framing process

NEXT UP. . .ELECTRICAL!  Getting closer every day!


Leave a Reply

Your email address will not be published.